Journal Entry #0061
2025-12-17, Anthony Remark, Marian Scientific, AMDG
Yesterday, When the Mounted seven segment displays arrived, I realized I has a little problem. This is a front that was designed by myself for MM1 Minute hand.
So we had a little problem. The slots cut out at the top were for smaller Seven segment displays. No matter, the solution was to either go
with the original plan, which was to use a small perf board and solder everything needed. And this would take hours. OR
Today, we acquired plywood and cut out the necessary parts.
This material had maple veneers on both sides and a particle board middle.
